All RIDA stories

RIDA Journal / Factory

Equipment and tooling, up close

Four workshop photographs show copper coils on circular holders, vertical tooling, the inside of a lathe and paired fixtures.

RIDA factory photographs

Vertical columns, a central fixture and the surrounding work area.
Vertical columns, a central fixture and the surrounding work area.View full photograph ↗

Vertical tooling

The vertical columns and central tooling form the main structure in this photograph. Nearby coils and fixtures place the equipment in its working environment.

Copper coils, circular holders and the equipment control panel.
Copper coils, circular holders and the equipment control panel.View full photograph ↗

Coil workstation

Copper coils sit on circular holders beneath the equipment enclosure. The control panel and work area can be seen together, showing the layout of this workstation.

The chuck, tool post and metal chips inside a lathe.
The chuck, tool post and metal chips inside a lathe.View full photograph ↗

Lathe detail

This close-up shows the lathe chuck and tool post, with metal chips around the working area. For dimensions and tolerances relevant to your product, request the drawing for the exact model.

Two side-by-side fixtures within an enclosed workstation.
Two side-by-side fixtures within an enclosed workstation.View full photograph ↗

Paired fixtures

Two fixtures sit side by side within the enclosure. Guides, cabling and connecting tubes are visible around them.

Have a product or application in mind?

Share the series, model or working conditions you know so the discussion can start with your requirements.

Explore pump series ↗Selection checklist ↗