RIDA Journal / Factory
Equipment and tooling, up close
Four workshop photographs show copper coils on circular holders, vertical tooling, the inside of a lathe and paired fixtures.
RIDA factory photographs

Vertical tooling
The vertical columns and central tooling form the main structure in this photograph. Nearby coils and fixtures place the equipment in its working environment.

Coil workstation
Copper coils sit on circular holders beneath the equipment enclosure. The control panel and work area can be seen together, showing the layout of this workstation.

Lathe detail
This close-up shows the lathe chuck and tool post, with metal chips around the working area. For dimensions and tolerances relevant to your product, request the drawing for the exact model.

Paired fixtures
Two fixtures sit side by side within the enclosure. Guides, cabling and connecting tubes are visible around them.
Have a product or application in mind?
Share the series, model or working conditions you know so the discussion can start with your requirements.